회차 | 제목 | 학습 |
---|---|---|
1 | tool / solid creation 1 - box, sphere, cone, pyramid | |
2 | tool / solid creation 2 - paraboloid, tube, torus, pipe | |
3 | tool / solid creation 3 - extrud solid-slab from polyline | |
4 | surface tool / fillet surface(예제), extand surface(예제), chamfer surface | |
5 | surface tool / variable radius suface fillet | |
6 | blend surface용 예제 | |
7 | blend surface 서피스 연결하기 | |
8 | blend surface용 복잡한 예제와 적용 | |
9 | offset surface, 콘트롤 포인트의 조절, connect surface | |
10 | symmetry, 두개의 서피스 사이에 단계를 만들기 | |
11 | control point,knot, UV의 개념 익히기 | |
12 | degree(차수)개념, rebuild curve로 curve 조절 | |
13 | rebuild surface로 서피스 조절, rebuild surface UV 로 방향 바꾸기 | |
14 | refit surface to tolerance로 공차값 줄이기, change surface degree | |
15 | untrim으로 서피스 내부를 복구하기, shrink suface trim | |
16 | replace surface edge, unroll developable surface와 치수 기입 | |
17 | flatten surface, smash, adjust surface end bulge | |
18 | zebra analysis와 curvature analysis로 연속성 확인 | |
19 | solid tool / boolean 기능 익히기 | |
20 | merge two coplanar faces, unjoin 명령 | |
21 | wire cut으로 솔리드 파내기, agline 명령으로 정렬 | |
22 | move face,extrude face, 솔리드를 control point로 변형하기 | |
23 | 예제로 정리하기 1 - 드라이기 송풍구 모델링 | |
24 | 예제로 정리하기 2 - 모종삽 모델링 |
Copyright(C) 2001
All rights reserved.